Triner Scale & Mfg. Co., Inc. MODEL TS-70PX / Xi
6
3.2.2.2 NEW ZIP CODE Key
The NEW ZIP CODE key is used to change the current destination ZIP code or Zone.
3.2.2.3 CLEAR (NO) KEY
The CLEAR/RESET key is used to clear the current entry, clear the special service fees
applied or to answer a YES/NO question. If an incorrect data entry is made, pressing this
key will only clear the current data from the display.
3.2.2.4 ZERO SCALE KEY
The ZERO SCALE key is used to Zero the scale. When this key is selected, the scale
zeros the weight.
3.2.2.5 ENTER (YES) KEY
The ENTER (YES) key is used to accept data when in data entry mode or answer a
YES/NO question.
3.2.3 FUNCTION KEYS
The function keys are used to access less frequently used scale operations.
3.2.3.1 PIECE COUNT
The Piece Count function puts the scale into a counting mode. Refer Section 5.1 for the
Piece Count operation procedure.
3.2.3.2 MANUAL WEIGHT
Pressing the manual weight button places the scale into the manual weight mode. In this
mode the user can input the weight of an item via the numerical keypad and perform rate
calculations. Press the manual weight button again to return to the normal weighing
mode.
3.2.3.3 MANUAL POSTAGE (1) KEY (TS-70Xi ONLY)
Pressing the manual postage (1 Key) places the scale into the manual postage mode. In
this mode the user can input the postage of an item via the numerical keypad and press
Enter, sending the postage to the meter.
3.2.3.4 AUTO CORRECT (2) Key (TS-70Xi ONLY)
This mode is used when there is already postage on the package but the postage is not
enough. First place the package on the scale and then select the class of service. Once
the rate is displayed, press the auto correct button (2 Key), which places the scale into
auto correct mode. In this mode the user will input the postage that is on the package.
The scale will then subtract the postage that is on the package from the total postage and
send the remaining amount that must be added to the meter.
To Next Page
Loading...
