Triner Scale TS-70PX - Getting Started with Your Scale; Scale Setup and Initialization

Triner Scale & Mfg. Co., Inc. MODEL TS-70PX / Xi
2
CHAPTER 2: GETTING STARTED
After unpacking the scale, a small amount of preparation is required before the scale can
be used for mailing or shipping. Please refer to Figure 2-1 below as needed.
INTERFACE
PORT
POWER
CONNECTOR
ON/OFF
SWITCH
Figure 2-1: TS-70PX / XI Back Panel
Step 1. Position the scale in its area of intended use. Observe the following guidelines
for suitable location:
• Choose a firm, stable floor or table.
• Do not share an AC outlet with electrical noise producing equipment, such as
refrigeration units. This includes products with electrical motors and/or relays.
• Do not place the scale in an area with changing ambient temperature and/or high
humidity.
• Do not place the scale in an area prone to exposure to direct sunlight, wind, or dust.
• Do not place the scale in an area with vibrating equipment.
Step 2. Connect the scale to postage meter interface cable (TS-70Xi Only).
Step 3. Install the AC Adapter.
1. After placing the scale in its area of use, locate the AC Adapter.
2. Connect the female end of the AC Adapter to the connector on the rear of
scale, and then plug the adapter into an AC outlet.
Step 4. Turn the scale’s AC power on to begin the initialization.
Step 5. Initialization - The first time the scale is turned on you may be
required to enter your origin ZIP Code.
1. When the AC power switch is placed “ON” position, the scale prompts for your
“origin ZIP Code ???”.
2. Enter the first three digits of your ZIP Code. The scale displays the ZIP Code
entered and prompts you to verify (Yes or No) if the ZIP Code displayed is
correct.
3. If the ZIP Code is correct, press the “Yes” (Enter) key to complete the
initialization or if the ZIP Code is incorrect, press the “No” (Clear) key and enter
the correct ZIP Code.