Triner Scale & Mfg. Co., Inc. MODEL TS-70PX / Xi
21
APPENDIX D: RATE CHANGE INFORMATION
D.1 RATE UPDATES
Triner updates USPS rate and structure changes. The rates and operating system
reside on one removable rate card.
When Postal Rates Change
To install your new Rate Chip:
1. Turn the scale off and unplug the adapter from the wall outlet. If the scale is connected to a
remote device, unplug that connection also.
2. The rate chip compartment is located on the right side of the scale. Most scales have a
stainless steel cover plate that protects the chip from theft. Remove this plate by removing the
two screws that hold it in place.
3. Use a small flat head screw driver and gently pop open the plastic rate chip cover plate.
4. Remove the rate card by grasping the edges and pulling towards you.
5. Insert the new rate card (The rate card can only be installed in one direction. If it does not fit
properly, turn it over and re-insert). Make sure the card is fully inserted into the slot.
6. Replace the Rate Chip Compartment cover(s).
7. Re-connect the adapter .
8. Your scale is now ready for use with its new, updated rates.
To Next Page
Loading...
