Triner Scale TS-70PX - Advanced Feature: Piece Counting; Piece Counting Procedure

Triner Scale & Mfg. Co., Inc. MODEL TS-70PX / Xi
12
CHAPTER 5: ADVANCED FEATURES AND OPERATION
5.1 PIECE COUNTING
This function is used to count items of identical weight. To maintain the count accuracy,
the following guidelines should be followed:
• All items placed on the scale must be of the same weight.
• The minimum sample count is 10.
• The minimum weight per piece must be 0.1 ounces for a sample count of 10.
• The total weight of the items sampled must be 1 ounce or greater.
1. Remove all items from the scale.
2. Press the ZERO key.
3. Press the PIECE COUNT key. The scale prompts you to place a 10-piece sample
count on the scale.
4. Place the 10-piece sample count on the scale. The scale prompts you to press the
ENTER key.
5. Press the ENTER key.
6. Remove the sample count from the scale.
7. Place the items to be counted on the scale. As items are added to or removed from
the scale the display reflects count.
8. Press the CLEAR key to return to normal scale operation.
NOTE: If the total weight of 10 samples is less than 1 ounce, it will not register
as a full sample. If this occurs, press the ENTER key and the scale will prompt
for a 20-piece sample count.