ASSEMBLY INSTRUCTIONS
STEP 1
Carefully lay SINK (A) upside-down on a
smooth flat surface. Two people are
needed. Do NOT attempt this alone.
Attach LEGS (B) to four corners of sink
bottom with SCREWS (D). Make sure
hole on each leg for mounting shelf is
facing inward as shown with arrow. Align
holes on end plate of leg to holes on sink
bottom corner. Insert SCREW (D) into
each aligned hole and loosely tighten with
Phillips screwdriver.
Note: Screwdriver not included
D
B
!
A
STEP 2
Slide SHELF (C) between four LEGS (B) as
shown. Make sure SHELF (C) back side is
facing up. Align hole on each corner of
SHELF (C) to hole on leg. Insert SCREW (D)
into aligned hole and tighten fully with
Phillips screwdriver.
Fully tighten all screws in step 1 with
Phillips screwdriver.
C
D
4
To Next Page
Loading...
