ASSEMBLY INSTRUCTIONS
STEP 5
Carefully move sink against wall at your desired location. If needed,
use a pencil to mark off mounting height of BRACKET (G).
Position BRACKET (G) on wall, marking off fastening location on wall
through holes on BRACKET (G). Drill holes in marked locations. Insert
ANCHOR (I) completely into each drilled hole. Fasten MOUNTING
SCREWS (H), through holes on BRACKET (G), into anchors tightly with a
screwdriver.
Slightly lift sink and hook flange of sink over BRACKET (G). Adjust Feet
Levelers to ensure sink is stable and level. Connect drain to plumbing
system.
Note: Bracket is to prevent sink tipping, NOT for mounting sink to a
wall. Do NOT mount sink to a wall without legs.
G
I
H
G
STEP 6
Place SINK GRID (J) inside SINK (A).
J
7
To Next Page
Loading...
