TRIOMED COMPACT. USER MANUAL
20
To conrm that the device is working in accordance with
the programme selected, the corresponding LEDs (g 3-10)
are switched on and a sound signal is produced briey
at certain intervals (3-4 sec).
To use the device without sound, enter again the pro-
gramme selection mode by pressing and holding the con-
trol button. Wait for the LED combination selected earlier
and release the control button. The device is programmed
to switch on the sound in every other programme selection
cycle.
The device memorises and activates at the next start-up
the programme used in the previous session. A brief press
on the control button switches the device on and activates
the programme that has been memorised skipping the se-
lection mode. The programme currently in use is indicated.
Having nished its operation according to the pro-
gramme selected the device switches o automatically.
The device can be switched o at any time by pressing
the control button.
4.3. Use of the device
Decide on the suitable treatment programme (Section 11.1).
Find out the LED combination which indicates it (Fig. 3-10).
Switch on the device and select the programme.
The device will activate the programme and start gener-
ating radiation after you release the control button.
To Next Page
Loading...
