4
OPERATING HINTS
1) Use cool water only. Hot water may set a
stain.
2) Use the built-in agitation brush to help free
up stain.
3) Continually check for foam buildup in
recovery tank. Use a distributor
recommended foam control solution.
NOTE: Excessive foam buildup will cause
damage to the vacuum motor.
4) Repeat extraction path on heavily soiled
areas.
5) When recovery of the dirty solution ends, or
the solution tank is empty, you must drain
the recovery tank. (see TANK DRAINING)
DRAINING TANKS
DRAINING SOLUTION TANK
1) Turn machine off and unplug from power
source.
2) Disconnect solution and vacuum hoses
from front of machine.
3) Unhook clamps on recovery tank and
remove recovery tank from machine.
4) Carry solution tank to an approved drain,
and dump out contents.
DRAINING RECOVERY TANK
1) Turn off machine and unplug from
power source.
2) Unhook clamps on recovery tank and
remove recovery tank from machine.
3) Carry recovery tank to an approved
drain and dump out contents.
4) Rinse recovery tank with clean water.
5) Reattach recovery tank to the solution
tank.
To Next Page
Loading...
