3
CARPET SPOTTER - SETUP
!!! Read operators manual thoroughly
prior to operating or servicing this
machine!!!
Carefully check the shipping carton for signs
of damage. Report any carton damage to
carrier immediately.
Check carton contents to ensure carton is
complete. Contact your distributor if anything
is missing.
Contents:
z Carpet Spotter
z Vacuum & Solution hoses
z Hand tool
!!! Read operators manual
thoroughly prior to operating or
servicing this machine!!!
1) Using a hose or bucket, fill tank with a
maximum of 1 gallon of water.
!!! Do not use flammable liquids or
operate machine in or near
flammable liquids or vapors!!!
2) Connect the solution hose and vacuum
hose to the machine.
3) Connect the power cable to a grounded
wall outlet. (see grounding instructions)
MACHINE OPERATION
PRIOR TO REMOVING SPOTS
1) Inspect power cable for damage.
Replace cable if damage is found.
2) Vacuum carpet to remove debris prior to
extracting the spot.
SPOT REMOVAL
1) Turn on vacuum / pump switch.
NOTE: Solution will only spray when the
spray handle(on the hand tool) is pulled.
2) To start cleaning, pull the spray handle
(hand tool) and begin to pull the tool
backwards over the spot.
NOTE: For best cleaning results, use
the built-in agitation brush on the hand
tool to help loosen stain.
3) Release spray handle when you have
reached the end of the spot. Continue to
pull hand tool back for another 4 inches to
pick up excess solution.
4) Continue until spot is removed.
To Next Page
Loading...
