6
Disclaimer
Before installation, check the following settings of your source(s)
and TV/monitor(s):
1. Set to display 60 Hz. Double-check factory settings, in case the default
is set to a lower frequency (Hz) than advertised.
2. Ensure the input setting of your monitor is set at HDMI 2.0 or DisplayPort
1.2a. Some displays may have default setting at HDMI 1.4.
Note: This is only important for the B127A-1A1-BDBH model; the B127A-1A1-
BDBD, B127A-110-BD and B127A-111-BDTD
will need DP 1.2a settings.
3. Check if the Ultra HD (UHD) Deep Color setting is enabled on your TV/
monitor. Confirm with your TV/monitor manufacturer which HDMI ports
support UHD Deep Color.
Note: Only for the B127A-1A1-BDBH model.
4. Check the USB/IR DIP switch, as the default setting is set to "IR".
Notes: Only for the B127A-1A1-BDBH and B127A-1A1-BDBD models.
The B127A-111-BDTD and B127A-110-BD units do not have IR/USB ports
or a DIP switch.
To connect a local monitor to your installation, the UHD Deep Color setting
may need to be disabled on your local TV/monitor (depending on the
make/model) to achieve 4K/60 Hz resolution.
21-03-131 933D25 RevC.indd 621-03-131 933D25 RevC.indd 6 3/22/2021 3:19:54 PM3/22/2021 3:19:54 PM
To Next Page
Loading...
Need help?
General
