Tripp Lite NetCommander B070-008-19 - Netcommander Server Interface Units

Up to 100 ft
6
NetCommander Server Interface Unit (SIU)
The NetCommander Server Interface Unit
The Server Interface Unit gets its power from the connected computer. In the case of the
NetCommanderPS/2ServerInterfaceUnit(B078-101-PS2),thepowerisdrawnfromthe
keyboard port. In the case of the NetCommander USB Server Interface Unit (B078-101-
USB),thepowerisdrawnfromtheUSBport.Whenconnectedandreceivingpower,the
greenLEDontheSIUwillilluminate.WhenconnectedtotheactiveportontheKVM,the
orange LED will illuminate.
Connecting a NetCommander PS/2 Server Interface Unit (Model # B078-101-PS2)
1. Shut down the computer being connected to the B078-101-PS2 (SIU)
2. Connect the B078-101-PS2 VGA connector to the computers VGA port
3. Connect the B078-101-PS2 PS/2 Keyboard connector to the computers PS/2 Keyboard port
4. Connect the B078-101-PS2 PS/2 Mouse connector to the computers PS/2 Mouse port
5.ConnectoneendoftheCat5patchcabletotheRJ45portontheB078-101-PS2*
6.ConnecttheotherendoftheCat5patchcabletothedesiredRJ45portonthe
 ConsoleKVM.*ThegreenLEDwillilluminatewhenconnectedandreceivingpower.
7. Repeat these steps for each additional PS/2 computer/server you are connecting to the
Console KVM
Installation (continued)
Figure 4 NetCommander PS/2 Server Interface Unit
SIU = Server Interface Unit
201002116 93-2925.indd 6 3/15/2010 11:48:42 AM