To Next PageTo Next Page
Need help?Do you have a question about the Tripp Lite PDUMVR20NET and is the answer not in the manual?
Essential warnings and guidelines for safe installation and operation of the PDU.
Covers methods for securing the PDU in a rack.
Instructions for connecting the PDU to power and equipment.
Steps for assigning an IP address automatically via DHCP.
Procedures for manually setting a static IP address for the PDU.
Steps to configure PDU network settings using terminal emulation.
Setting up IPv4, IPv6, DNS, and hostname for network connectivity.
Essential warnings and guidelines for safe installation and operation of the PDU.
Covers methods for securing the PDU in a rack.
Instructions for connecting the PDU to power and equipment.
Steps for assigning an IP address automatically via DHCP.
Procedures for manually setting a static IP address for the PDU.
Steps to configure PDU network settings using terminal emulation.
Setting up IPv4, IPv6, DNS, and hostname for network connectivity.
General| Model | PDUMVR20NET |
|---|---|
| Category | Power Distribution Unit |
| Input Frequency | 50/60Hz |
| Output Outlets | 20 |
| Maximum Output Current | 20A |
| Monitoring | Yes |
| Remote Management | Yes |
| Network Management | Yes |
| Interface Port | RJ45 |
| Voltage Monitoring | Yes |
| Current Monitoring | Yes |
| Power Monitoring | Yes |
| Form Factor | Rackmount |
| Rack Units (RU) | 1U |
| Mounting | Horizontal |
| Outlet Type | IEC 60320 C13 |
| Network Interface | Ethernet |
| Environmental Monitoring Port | Yes |
| Operating Temperature | 0 to 40°C |
| Operating Humidity | 0-95%, non-condensing |
| Safety Certifications | CE |
