Tripp Lite SMART1500LCD

To Next Page

1111 W. 35th Street • Chicago, IL 60609 USA

www.tripplite.com/support

Owner’s Manual

SMART1200LCD, SMART1500LCD &

OMNI1500LCD

Not suitable for mobile applications.

English Español Français

5 9

Important Safety Instructions

SAVE THESE INSTRUCTIONS

This manual contains instructions and warnings that should be followed during the installation, operation and storage of all Tripp Lite UPS Systems.

Failure to heed these warnings may affect your warranty.

UPS Location Warnings

• The UPS is designed for indoor use only in a controlled environment, away from excess moisture, heat/cold, conductive contaminants, dust or

direct sunlight.

• Leave adequate space around all sides of the UPS for proper ventilation.

• Do not mount unit with its front or rear panel facing down (at any angle). Mounting in this manner will seriously inhibit the unit's internal

cooling, eventually causing product damage not covered under warranty.

UPS Connection Warnings

• Connect your UPS directly to a properly grounded AC power outlet. Do not plug the UPS into itself; this will damage the UPS.

• Do not modify the UPS’s plug, and do not use an adapter that would eliminate the UPS’s ground connection.

• Do not use extension cords to connect the UPS to an AC outlet.

• If the UPS receives power from a motor-powered AC generator, the generator must provide clean, filtered, computer-grade output.

• The UPS contains its own energy source (battery). The output terminals may be live even when the UPS is not connected to an AC supply.

Equipment Connection Warnings

• Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the failure of the life support

equipment or to significantly affect its safety or effectiveness is not recommended. Do not use this equipment in the presence of a flammable

anesthetic mixture with air, oxygen or nitrous oxide.

• Do not connect surge suppressors or extension cords to the output of your UPS. This might damage the UPS and may affect the surge suppressor and

UPS warranties.

Battery Warnings

• Your UPS does not require routine maintenance. Do not open your UPS for any reason. There are no user-serviceable parts inside.

• Batteries can present a risk of electrical shock and burn from high short-circuit current. Observe proper precautions. Do not dispose of the batteries

in a fire. Do not open the UPS or batteries. Do not short or bridge the battery terminals with any object. Unplug and turn off the UPS before performing

battery replacement. Use tools with insulated handles. There are no user-serviceable parts inside the UPS. Battery replacement should be performed

only by authorized service personnel using the same number and type of batteries (Sealed Lead-Acid). The batteries are recyclable. Refer to your local

codes for disposal requirements or visit www.tripplite.com/UPSbatteryrecycling for recycling information. Tripp Lite offers a complete line of UPS

System Replacement Battery Cartridges (R.B.C.).Visit Tripp Lite on the Web at www.tripplite.com/support/battery/index.cfm to locate the specific

replacement battery for your UPS.

• Do not attempt to add an external battery pack to the UPS.

WARRANTY

REGISTRATION:

chance to win a FREE Tripp Lite

product—www.tripplite.com/warranty

Main Page

Other manuals for Tripp Lite SMART1500LCD

Specifications5 pages

Need help?

Do you have a question about the Tripp Lite SMART1500LCD and is the answer not in the manual?

Tripp Lite SMART1500LCD Specifications

General

Model	SMART1500LCD
Type	Line Interactive
Capacity	1500VA / 900W
Output Voltage	120V
Input Voltage	120V
LCD Display	Yes
Output Voltage Regulation (Battery Mode)	+/- 5%
Input Frequency	50/60 Hz
Input Connection Type	NEMA 5-15P
Output Connections	NEMA 5-15R
Typical Recharge Time	8 hours
Audible Alarm	Yes
Interface Port	USB
Battery Type	Sealed Lead Acid (SLA)
Outlets	8 NEMA 5-15R
Data Line Protection	RJ45
Transfer Time	4 milliseconds
Input Voltage Range	83 - 147V