10 Power Precision Cooker™ | Model: CTO5OP102
Care & Maintenance
Before performing any care or maintenance on this Unit, be certain that
the AC cord is unplugged from the wall outlet and the Unit has thoroughly
cooled.
Clean After Use
1. Unplug the Unit before cleaning.
2. Wipe with a cloth and set to dry.
3. Place on dish rack to dry.
Caution
Important
• DO NOT perform any service
work on the electronic
components of this unit.
Such work should only be
performed by the factory or a
certified professional.
• The Power Precision Cooker
should never come in direct
contact with food or any liquid
other than clean water.
• Do not operate the Power
Precision Cooker without
the Skirt and Circulator Cap
attached properly.
You may want to clean the inside of
the Unit if the food bag broke and
contents spilled out.
1. Remove the Skirt
Firmly grasp the unit with two hands
while pressing the top of the Clamp
(FIG. A) and twist the lower section
counterclockwise until the Arrow on
the Skirt aligns with the Open Lock
Icon on the upper handle. Pull down
and Skirt will separate from the upper
handle.
2. Remove the Circulator Cap
Twist to remove the Cap from the Skirt
(FIG. C). Both the Cap and the Skirt
can be placed in your dishwasher for
easy cleaning.
3. Clean the Heating Coil, Pump
Shaft, and Sensors
To clean the Heating Coil, Pump
Shaft and Sensors (FIG. B), use
a mild dish detergent with warm
water and a soft toothbrush. Rinse
thoroughly with warm water and allow
to dry before reassembling.
4. Replace the Skirt
Align the Arrow on the Skirt with the
Open Lock Icon on the upper handle
and push up (FIG. D). Then, while
holding the top of the Clamp, twist the
lower section counterclockwise until
the Arrow on the Skirt aligns with the
Closed Lock Icon on the upper handle.