INSTAFLOW
11
FITTING THE UNIT TO THE WALL
IMPORTANT: The unit must be mounted
in a vertical position only with the water
connections at the bottom.
Unscrew the fixing screw at the bottom of the
heater and remove front cover.
Entry position for the mains water is at the
bottom only.
Electrical supplies are at the side or rear of the
water heater.
Using the backplate as a template, mark the
two wall fixing holes (fig.5 and fig.6). Drill and
plug to suit the fixing screws supplied.
Screw the top fixing screw into position leaving
the base of the screw head protruding 6mm
out from the wall.
Hook the backplate over the top screw and
fit the bottom fixing screw into position, but
DO NOT fully tighten the screws at this stage.
The fixing holes are elongated to allow for
out of square adjustment after the plumbing
connection has been completed.
OUTLET
Wall mounting hole
Wall mounting hole
Fig.6
Wall mounting hole
Wall mounting hole
Fig.5
To Next Page
Loading...
