Assembly Tips:
Attention: If you are using an electric screw driver in assembly, please set at low torque and
do not over tighten the hardware. When assembling individual parts, loosely tighten screws
until all screws are inserted, then tighten completely.
Assembly Instructions
NOTE: Parts are packed inside the table cabinet. Remove the pool table surface (#38), inside
the table cabinet you will find all the parts needed to assemble your table.
PRE-INSTALLED PARTS
Lock Seat
4pcs
Bolt
2pcs
Motor
1pc
Washer
4pcs
Nut
2pcs
Nut
8pcs
NOTE: We recommend that two adults work together to assemble this game.
Find a clean, level place to begin the assembly of your Air Hockey Table. The table will be
assembled upside down and then turned over on its legs once the assembly is completed.
Remove all the parts from the box and verify that you have all of the parts as shown on the
parts list above. Carefully cut or tear the four corners of the box so that the bottom of the box
can be used as your work surface.
To Next Page
Loading...
