74
Maintenance and Adjustment
• Install the reservoir cap ensuring that
the diaphragm seal is correctly
positioned between the cap and
reservoir body.
• Locate the black reservoir cover,
position the assembly to the frame
and secure with the screw previously
removed. Tighten the screw to
62 lbf in (7 Nm).
Steering/Wheel Bearings
Steering Inspection
Lubricate and inspect the condition of the
steering head (steering) bearings in
accordance with scheduled maintenance
requirements.
Note:
• Always inspect the wheel bearings
at the same time as the steering
bearings.
To prevent risk of injury from the
motorcycle falling during the inspection,
ensure that the motorcycle is stabilized and
secured on the support.
Do not exert extreme force against each
wheel or rock each wheel vigorously as this
may cause the motorcycle to become
unstable or cause injury by falling from its
support.
Ensure that the position of the support
block will not cause damage to the oil lines
or oil filter beneath the sump.
To Next Page
Loading...
Need help?
General
