16 of 20
Models Fitted with Rear Side Reflectors
• Read the warning notices printed on the cleaning
wipe packet.
• The surface to which the reflector is affixed must
be clean and dry to ensure that the adhesive has
a sound base to adhere to. Use the cleaning wipe
supplied for this purpose.
1. Using the cleaning wipe provided, clean the area
of both panniers prior to fastening each
reflector, as shown below.
1. Cleaning area
2. Peel the protective film from the back of each
reflector.
3. Fit one reflector to each pannier, in the position
shown, ensuring the surface of the pannier is
clean and free from grease.
1. Reflector
When fitting self-adhesive parts care must be taken
to ensure positioning is correct and accurate. Once
the adhesive has been attached to the mounting
surface, there is no satisfactory method of removal
or re-positioning if incorrectly aligned. Initial
bonding is instant, full bonding is achieved after
72 hours.
Failure to fit a reflector to each pannier as shown
may contravene the law of your country, state or
territory. This will render the motorcycle illegal for
road use where such laws apply. Always fit
reflectors as shown.
Do not fit a reflector to each pannier in Japan as
this will contravene Japanese law and render the
motorcycle illegal for road use.
To Next Page
Loading...
