Triumph Rocket 3 GT 2021 - Page 1304

1266
7. Fit the rear subframe front bridge with its washers and fixings. Tighten the fixings to
12 Nm in the sequence shown.
Rear Subframe Front Bridge Tightening Sequence
8. Fit the passenger seat backrest (see Passenger Seat Backrest - Installation).
Perform the following operations:
• Battery - Installation
• Seat - Installation
Rear Subframe – Removal
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.