1366
9. Remove the front fork (see Front Forks - Removal).
10. As the fork is released, slide the direction indicator clamp off the fork and remove.
Note the routing of the direction indicator harness around the bracket for installation.
11. Remove the fixing detach the harness from the bracket and remove the front
direction indicator.
Perform the following operations:
• Seat - Removal
• Battery - Removal
• Flyscreen - Removal
Front Direction Indicators – Installation
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
1. Route the direction indicator harness to the bracket as noted for removal.
2. Fit the front direction indicator to its bracket with a new fixing.
3. Position the direction indicator clamp end between the upper and lower yokes and fit
the front fork (see Front Forks - Installation).
4. Position the direction indicator as noted for removal and tighten its clamp fixing to 3
Nm.
To Next Page
Loading...
