Triumph Rocket 3 GT 2021 - Page 524

496
Gear Change Actuator Shaft – Removal
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
Perform the following operations:
• Seat - Removal
• Battery - Removal
• Fuel Tank - Removal
• Engine - Removal
• Lower Crankcase - Removal
NOTICE
Note the orientation of the gear change actuator shaft for installation.
1. Remove the E-clip and washer from the gear change actuator shaft. Discard the E-
clip.
1. E-clip
2. Washer
3. Actuator shaft
4. Lower crankcase