Maintenance
152
Bulb Replacement
Caution
The use of non-approved bulbs may
result in damage to lenses and other
lighting unit components.
In addition, the use of bulbs of
incorrect wattage may cause the
chassis ECM to cut power to affected
lighting circuits.
Use genuine Triumph supplied bulbs
as specified in the Triumph Parts
Catalogue.
Always have replacement bulbs
installed by an authorised Triumph
dealer.
Headlights
The headlight unit is a sealed,
maintenance free LED unit. The
headlight unit must be replaced in the
event of the failure of the headlight.
Direction Indicator Lights
The motorcycle is fitted with either LED
or bulb direction indicator lights.
LED Direction Indicator Lights
The direction indicator light units are
sealed, maintenance free LED units.
Bulb Direction Indicator Lights
2
1. Indicator lens
2. Screw
To replace the direction indicator light
bulb:
• The lens on each indicator light is
held in place by a screw located in
the body of the light.
• Release the indicator lens screw.
• Remove the lens to gain access to
the bulb for replacement.
• Replace the bulb.
• Refit the lens making sure that the
locating tang is correctly aligned to
the indicator body.
• Tighten the indicator lens screw to
1 Nm.
License Plate Light
The license plate light unit is a sealed,
maintenance free LED unit.
Rear Light
The rear light unit is a sealed,
maintenance free LED unit.
To Next Page
Loading...
