72
Rider’s Seat Installation
To install the rider’s seat:
• Position the seat’s front bracket
under the fuel tank hinge and the
rear location into position in the
rear subframe.
1
2
3
1. Rider’s seat
2. Front bracket
3. Fuel tank hinge
• Secure the rider’s seat to the seat
lock plate with the two fixings.
• Tighten to 9 Nm.
Note:
• The fuel tank support is located on
the underside of the rider’s seat,
see page 105.
Side Stand
Warning
The motorcycle is fitted with an inter-
lock system to prevent it from being
ridden with the side stand in the down
position.
Never attempt to ride with the side
stand down or interfere with the inter-
lock mechanism as this will cause a
dangerous riding condition leading to
loss of motorcycle control and an acci-
dent.
1
1. Side stand
The motorcycle is equipped with a side
stand on which the motorcycle can be
parked.
When using the side stand, always turn
the handlebars fully to the left and
leave the motorcycle in first gear.
Whenever the side stand is used before
riding, always make sure that the stand
is fully up after first sitting on the mo-
torcycle.
For instructions on safe parking, refer
to the 'How to Ride the Motorcycle' sec-
tion.
To Next Page
