Triumph T595 Daytona User Manual

How to Ride the Motorcycle
1. Engine Stop Switch
TO START THE ENGINE
2.
Starter Button
3. Neutral Indicator Light
4. On Position
5. Ignition Switch
TO STOP THE ENGINE
l Close the throttle completely.
l Check that the engine stop switch is
in the run position.
.
Ensure that the transmission is in
neutral.
.
Pull the clutch lever fully in to the
handlebar.
l Select neutral.
l Turn the ignition switch off.
l Support the motorcycle on a firm,
level surface with the side stand.
l Lock the steering.
A
!
CAUTION: The engine should
normally be stopped by
turning the ignition switch off. The
engine stop switch is for emergency
l Turn the ignition switch on.
l Leaving the throttle completely
closed, push the starter button until
the engine starts.
NOTE:
l In very cold conditions, part open
the throttle to aid starting. Return
throttle to the closed position once
the engine has started.
poisonous and can rapidly cause loss
of consciousness and death within a
Always operate your motorcycle in
the open-air or in an area with
adequate ventilation.
Page 28

Triumph T595 Daytona Specifications

General

Displacement	955 cc
Compression Ratio	12.0:1
Transmission	6-speed
Frame	Aluminum beam perimeter
Rear Brakes	Single 220 mm disc, 2-piston caliper
Front Tire	120/70 ZR17
Rear Tire	190/50 ZR17
Bore x Stroke	79 mm x 65 mm
Rear Suspension	Monoshock, adjustable
Front Brakes	Twin 320 mm discs, 4-piston calipers
Dry Weight	198 kg (436 lbs)
Fuel System	Sequential, multi-point fuel injection