Triumph Thunderbird - General Information; Clock and Trip Meter Adjustment; Fuel Gauge and Range to Empty

23
General Information
Clock Adjustment
To reset the clock, select the clock display.
Then press and hold the scroll button
(see page 30) for 4 seconds, the clock’s hour
display will start to flash; release the scroll
button.
To reset the hour display, ensure the hour
display is still flashing then press the scroll
button to change the setting. Each individual
button press will change the setting by one
digit. If the button is held, the display will
continuously scroll through in single digit
increments.
When the correct hour display is shown,
release the scroll button for 4 seconds. The
minutes display will begin to flash. The
minutes display is adjusted in the same way
as for the hour display.
Once both hours and minutes are correctly
set, release the scroll button for 4 seconds
and the display will cease to flash.
Trip Meter Reset
To reset either of the trip meters, select and
display the trip meter to be zeroed. Then
press and hold the scroll button for
4 seconds. After 4 seconds, the trip meter on
display will reset to zero.
Range to Empty
This is an indication of the predicted distance
that can be travelled on the remaining fuel in
the tank.
Fuel Gauge
1. Fuel gauge
The fuel gauge indicates the amount of fuel
in the tank.
With the ignition switched on, the number of
bars shown in the display indicates the level
of fuel in the tank.
When the fuel tank is full all 16 bars are
displayed and when empty, no bars are
displayed. Other gauge markings indicate
intermediate fuel levels between full and
empty.
When 3 bars are displayed the low fuel
warning light will illuminate and the trip
meter will switch to 'Range to Empty' display
(see page 23). This indicates there are
approximately 4.5 litres of fuel remaining in
the tank and you should refuel at the earliest
opportunity.
If the ignition is switched off and on again,
without refuelling, the instrument will not
automatically display the Range screen again,
it will instead display the trip meter screen in
use before the fuel level became low.
Note:
• After refuelling, the fuel gauge
and range to empty information
will be updated only while riding
the motorcycle. Depending on the
riding style, updating could take
up to five minutes.
Warning
Do not attempt to adjust the clock with the
motorcycle in motion as this may lead to
loss of motorcycle control and an accident.
TRIP
1