Maintenance
170
Lights
Caution
The use of non-approved bulbs may
result in damage to lenses and other
lighting unit components.
In addition, the use of bulbs of
incorrect wattage may cause the
chassis ECM to cut power to affected
lighting circuits.
Use genuine Triumph supplied bulbs
as specified in the Triumph Parts
Catalogue.
Always have replacement bulbs
installed by an authorised Triumph
dealer.
Direction Indicator Lights
The motorcycle is fitted with either LED
or bulb direction indicator lights.
LED Direction Indicator Lights
The direction indicator light units are
sealed, maintenance free LED units.
Bulb Direction Indicator Lights
To replace the indicator bulb:
• The lens on each indicator light is
held in place by a securing screw
located either in the lens of the light
or the light housing.
• Release the screw and remove the
lens.
• Carefully remove the indicator bulb.
• Installation is the reverse of the
removal procedure.
Rear Light/Licence Plate Light
The rear light unit is a sealed,
maintenance free LED unit. The licence
plate light is integral to the rear light
unit.
Fog Lights (if fitted)
The fog light units are sealed,
maintenance free LED units.
To Next Page