General Information
87
Rider's Seat
Warning
The rider's seat is only correctly
retained and supported once the
passenger seat is correctly fitted.
Never ride the motorcycle with the
passenger seat detached or removed,
as the rider's seat will not be secure
and may move.
A loose or detached seat could cause
loss of motorcycle control and an
accident.
Rider's Seat Removal
1
1. Rider's seat
To remove the rider's seat:
• Remove the passenger seat (see
page 85).
• Grasp the rider's seat on either side,
and slide it rearwards and upwards.
• If fitted with heated seats,
disconnect the heated seat’s
electrical connector for complete
removal from the motorcycle.
Rider's Seat Installation
2
34
1
1. Upper bar
2. Lower bar
3. Seat bridge
4. Seat supports
To install the seat:
• Reconnect the heated seat’s
electrical connector (if fitted).
• Position the seat tongue under the
upper bar on the fuel tank for the
high seat position, or under the
lower bar on the fuel tank for the
low seat position (see page 88).
• Engage the seat's front rail into the
seat bridge at the rear of the fuel
tank and lower the rear rail onto the
seat supports.
• Push down firmly on the rear of the
seat and hold.
• Refit the passenger seat (see
page 85).
To Next Page
Loading...
