Trix MINITRIX Series - Safety Notes; General Notes; Functions; Notes on Digital Operation

8
Functions
• Built-inelectroniccircuitforoperationwithaconventional
DC power pack (max. ±12 volts), Trix Systems, Trix Selectrix
or NMRA DCC digital systems.
• Automaticsystemrecognitionbetweendigitalandanalog
operation.
• NoautomaticsystemrecognitionbetweenSelectrix(SX)and
DCC.
• Dualheadlightsfrontandrear,thatchangeoverwiththe
direction of travel.
Notes on digital operation
• Thersttimethelocomotiveisusedinadigitalsystem
(Selectrix or DCC), the decoder must be set for this digital
system. To do this, the decoder must be programmed once in
thisdigitalsystem(Example:changinganaddress).
• Thesettingdoneatthefactorydoesnotpermitoperationwith
opposite polarity DC power in the braking block. If you want
this characteristic, you must do without conventional DC
power operation (CV 29 / Bit 2 = 0).
No warranty or damage claims shall be accepted in those cases where parts
neither manufactured nor approved by Trix have been installed in Trix pro-
ducts or where Trix products have been converted in such a way that the
non-Trix parts or the conversion were causal to the defects and / or damage
arising. The burden of presenting evidence and the burden of proof thereof,
that the installation of non-Trix parts or the conversion in or of Trix products
was not causal to the defects and / or damage arising, is borne by the person
and/or company responsible for the installation and / or conversion, or by
the customer.
Safety Notes
• Thislocomotiveisonlytobeusedwiththeoperatingsystem
it is designed for.
• Thislocomotivemustnotbesuppliedwithpowersimultane-
ously by more than one power source.
• Pleasemakenoteofthesafetyinformationintheinstructions
for your operating system.
• Thefeedertrackmustbeequippedtopreventinterference
with radio and television reception, when the locomotive is to
be run in conventional operation. The 14972 interference sup-
pression set is to be used for this purpose. The interference
suppression set is not suitable for digital operation.
• Donotexposethemodeltodirectsunlight,extremechanges
in temperature, or high humidity.
• WARNING! Sharp edges and points required for operation.
General Notes
• Theoperatinginstructionsareacomponentpartofthe
product and must therefore be kept in a safe place as well
as included with the product, if the latter is given to someone
else.
• PleaseseeyourauthorizedTrixdealerforrepairsorspare
parts.
• http://www.maerklin.com/en/imprint.html