Trojan TH-80 - Operation and Warnings; Before and After Operation; Operation Guidelines

 7/19


CHAPTER4OPERATION,WARNINGS


4.1BEFORE&AFTER

CheckingIf DetailedItems
Bolts&Nuts
Loosing,MissingorDamage
ThroughBolt,SideBolt,AccumulatorBodyBolt,Accumulator
CoverBolt,etc.
Chisel&Surroundings
Missingordamage
Chisel, Chisel Pin, Stop Pin, Inner & Outer Bushes, Rubber
Plug,Circlip,etc.
Pipe&Hose
LoosingorLeaking
SteelPipe,RubberHose,Connectors,andtheWholePipeline,
etc.
OilLeaking BetweenChisel&Bush,BackHead&Cylinder,Accumulator&
Cylinder,etc.
Lubrication Lubricatewithgreaseafterevery2or3workinghours.
HydraulicOil
Clean,Sufficientornot

(#46HydraulicOilforhotweather)
(#68HydraulicOilforcoldweather)
If it is hammer’s first running , please change new oil within
250 working hours, and change new oil filter within 50
workinghours.Afterthefirstchanging,pleasechangenewoil
within 600
 working hours, and new oil filter within 100
workinghours.


4.2OPERATION


 TheChiselshouldbepressedhardandverticallytotheobjecttobebroken.
 Steponthepedal,thehammerwillstrike.
 Onceobjectisbroken,stopstrikingimmediately.

 Don’tworkcontinuouslyinhotsummer,topreventtoohightemperatureofhydraulicoil.If
oiltemperaturereaches80
degreescentigrade,muststopworking,untilthetemperaturelowersdown.






