GB/IE/NI 22
The current consumption of the connected device might be
too low.
Check with your connected device manual and see if your
connected device current consumption comply with this
product. The minimal output current of the power bank is
approx. 100 mA.
The power bank does not react when
the button is pressed or when a device is
connected, even though the battery is charged.
The power consumption of the connected devices is too
high. Therefore, the internal overcurrent protection device
was activated.
Reduce the number of devices connected and press the
On/off button
3
.
Wireless charging did not start
Device to be charged is not placed at the centre of the Qi
charging surface
4
of the power bank.
Make sure your device to be charged is at the correct
position at the centre of the Qi charging surface
4
of the
power bank.
Make sure that there are no other objects on the Qi
charging surface
4
.
Remove your device‘s protective case as it may be blocking
the wireless signal.
Wireless charging speed slow
Device to be charged is too far away from the centre of the
Qi charging surface
4
.
Make sure your device to be charged is at the correct
position at the centre of the Qi charging surface
4
of the
power bank.
To Next Page
Loading...
Need help?
General
