Tronic TKHU 2 A2 User Manual

GB
│
IE
│
13 ■TKHU 2 A2
Handling and use
Fitting the car cradle
♦ Unscrew the screw ring 4 anticlockwise from the
car cradle.
♦ Place the screw ring 4 over the ball joint 9 and
press the ball joint 9 into the ball joint socket 5
(see fig. C).
♦ Screw the screw ring 4 clockwise onto the ball
joint socket 5 until tight
Fitting the vent clip
♦ Pull the lever 1 towards the car cradle and hold it
in place.
♦ Guide the hook 2 between two ventilation slots
and hook it onto a ventilation slot.
♦ Release the lever 1 slowly and, at the same time,
place the two cut-outs 3 onto a ventilation slot.
♦ Align the car cradle so that the two arms of the vent
clip rest on the fitting. You can use the 360° rotating
ball joint 9 to adjust the car cradle horizontally
and vertically to suit your requirements. Loosen the
screw ring 4 a little to make it easier to adjust the
ball joint 9.

Tronic TKHU 2 A2 Specifications

General

Brand	Tronic
Model	TKHU 2 A2
Category	Automobile Accessories
Language	English