To Next PageTo Next Page
Need help?Do you have a question about the TroposAir Liberator and is the answer not in the manual?
Install the mounting bracket to the ceiling outlet box using provided hardware.
Assemble and attach the downrod to the fan motor assembly.
Lift and secure the fan assembly onto the installed mounting bracket.
Securely attach the safety cable to the ceiling joist for added support.
Attach fan blades to the fan motor using screws and washers.
Confirm receiver and transmitter model/serial numbers match for proper operation.
Carefully insert the receiver into the fan's mounting bracket.
Follow wiring diagram to connect all electrical wires securely.
Mount and secure the canopy to cover the wiring and mounting bracket.
Install battery and check dip switch settings on the remote transmitter.
Install the 12V battery into the remote transmitter.
Verify dip switch settings for LED dimming or ON/OFF control.
Securely re-attach the back cover of the remote transmitter.
Learn how to operate the fan and light functions using the remote control.
Adjust fan speed from 1 (low) to 5 (high).
Use the reverse switch to change the fan's blade direction.
Set the fan timer for 1, 4, or 8 hours of operation.
Steps to diagnose and resolve common fan operational issues.
Verify all wire connections are secure after lowering the canopy.
Perform the pairing process if the remote is not functioning correctly.
Steps to pair the remote transmitter with the fan's receiver unit.
Pair a single transmitter with multiple fans or one receiver individually.
Configure the remote for the first fan in a multi-fan setup.
Configure the remote for the second fan in a multi-fan setup.
Reconnect all fans after individual setup and pairing.
General
