Trotec Airlock 100 - AirLock 100;200 Installation Guide; Prepare Window and Apply Velcro Strap (Side A); Attach Velcro Strap (Side B) to Casement; Secure Wide Side (A) to Window Frame

EN
2
First open the window and clean the
surfaces to be bonded from dust and
fat on the window frame and case-
ment. Open the Velcro fastener and
stick the Velcro strap to the window
frame (side A).
Never stick it to the contact surface
of the window seal (window must
still be able to close)!
Stick Velcro strap (side B) to the
a) outside or b) inside of the window
casement (side of the window handle).
Be sure that the window still is
able to close. Before sticking
together make sure that the sticky
tape doesn’t damage the window
frames!
Stick the narrow side B (zipper is
closed) from the middle to the left and
right side or to the up and down side
to the casement.
First stick the wide side A (zipper is
closed) with open windows from the
middle to the left and right side or to
the up and down side to the window
frame.
Close window and make sure that the
AirLock
100 / 200 isn’t clamped.
Open window slightly and pinch air
hose in the AirLock
100 / 200 by using
the zipper.
The AirLock
100 / 200 is ready for use
now.
1
2
3
4
5
6
7
B:Always attach narrow side of the AirLock 100 / 200
to the casement
A:


B
A
Begin with sticking here
Velcro strap
Casement
Velcro strap
inside or outside
Window frame
BA
B
A
Legend:
Mounting direction
Velcro strap
a)
b)
Installation instructions AirLock 100 / AirLock 200
AirLock 200
AirLock 100
AirLock 200
AirLock 100
AirLock 200
AirLock 100