8 Operating manual – Oil heater IDE 20 / IDE 30 / IDE 50 / IDE 60 / IDE 80 EN
• Switch off the device as described in the chapter Functions
and operation:
• Wait until the device has cooled down completely.
• Before transporting or moving the device, make sure that the
tank cap is tightly closed.
Risk of environmental pollution!
Fuel oil may leak during transport or handling of the
device.
The filling plug of the tank cap does not ensure
tightness in order to allow air to be introduced and to
be able to drain the tank during operation.
Transport or move the device only when the tank cap
is tightly closed.
For a smooth operation of the device, the combustion chamber,
the burner and the fan must be cleaned regularly.
• Switch off the device as described in the chapter Functions
and operation:
• Wait until the device has cooled down completely.
Cleaning after every 50 operating hours
• Remove the fuel oil filter. Take out the filter insert and clean
it with clean fuel oil.
• Dismantle the upper part of the housing and clean the inner
section and the fan blades with a cleaning fleece and, in case
of heavy soiling, with a brass brush.
• Check the condition off all cables and of the high-voltage
plugs.
• Dismantle the burner and clean its components with a brass
brush.
• Clean the electrodes. Check the distance of the electrodes
and adjust if necessary (see figure).
• Have the combustion chamber cleaned by the customer
service.
• Assemble the components in reverse order.
Cleaning the oil heater
• Wipe the outside of the device with a damp cloth. Painted and
plastic surfaces must not be scrubbed. Do not use any
cleaners containing solvents.
The fuel must be drained from the tank of the oil heater and
collected.
Oil heater
In the European Union, electronic equipment must not
be treated as domestic waste, but must be disposed of
professionally in accordance with Directive
2002/96/EC of the European Parliament and of the Council of
27 January 2003 on waste electrical and electronic equipment
(WEEE). At the end of its life, please dispose of this instrument in
a manner appropriate to the relevant legal requirements.
Fuels
Fuel oil or diesel must be disposed of in accordance with the local
regulations.
Packaging
The packaging of the oil heater consists of cardboard/paper and
plastics. It must be disposed of into the appropriate containers or
at a recycling centre in accordance with the local regulations.
In case of technical problems please try to rectify the fault with
the help of the instructions in the chapter Troubleshooting before
contacting our customer service.
For further questions regarding the function and operation of the
oil heater as well as for more information in the case of damage
or else for warranty issues we are of course always happy to be
of service.
Please contact:
Trotec GmbH & Co KG
Grebbener Straße 7
D-52525 Heinsberg
Tel.: 49 (0) 2452 / 962 - 400
Fax: 49 (0) 2452 / 962 - 200
E-mail: info@trotec.de www.trotec.de
Transport
Care and maintenance
Disposal
Service and repair
To Next Page
Loading...
Need help?
General
