Trotec IR 2010 S User Manual

6 EN
radiant heater IR 2010 S
Assembly and start-up
Scope of delivery
• 1x Device
• 4x Mounting bracket
• 2x Wing nut
• 2 x Screw
• 4 x Washers
• 4 x Fastening screws
• 4x Wall plug
• 1 x remote control
• 1x manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Remove the transport protection(7) from the grille of the
radiant heater.
7
4. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Warning of electrical voltage
Risk of injury due to incorrect assembly!
Local or national regulations may apply for installation.
We recommend to have the installation carried out by a
qualified electrician.
Warning
Risk of fire due to improper installation!
There is a risk of fire if the required minimum
distances are not observed.
Observe the “Installation” section in the “Assembly and
start-up” chapter and the technical data in the
“Technical annex” chapter.
Mounting the wall holder
ü Use tools suitable for the intended task.
1. Fasten two mounting brackets in each case using two
washers, one wing nut and one screw.

Trotec IR 2010 S Specifications

General

Brand	Trotec
Model	IR 2010 S
Category	Electric Heater
Language	English