Need help?Do you have a question about the Trotec IR 2005 and is the answer not in the manual?
General| Brand | Trotec |
|---|---|
| Model | IR 2005 |
| Category | Electric Heater |
| Language | English |
Dangers from electrical voltage and hot surfaces. Keep children away from hot parts.
Instructions for safe use by children aged 3-8 and keeping children under 3 away from the device.
Rules for safe operation, including water exposure, object insertion, cable management, and avoiding automatic switches.
Use for heating surfaces in roofed and non-roofed outdoor areas like storage facilities, construction sites, and events.
Details on prohibited uses, required personnel qualifications, and residual risks like injury due to radiation.
Steps to take in an emergency: switch off, disconnect from mains, and do not reconnect defective devices.
Explanation of the safety thermostat that activates during overheating and turns the device off.
Identification of parts including control panel, mains switch, brackets, grille, heating rod, and remote control.
Instructions for safely transporting and storing the device to prevent damage and ensure proper conditions.
Details on unpacking the device and requirements for mounting the wall or ceiling holder.
Step-by-step guide on fastening mounting brackets to the device and holders.
Observe minimum distances from walls/objects, do not install behind doors, and ensure horizontal position.
Marking drill holes, drilling, inserting wedge bolts, and securing mounting brackets with washers and nuts.
Loosening wing nut to tilt the device to the desired angle (30°-45°) for wall or ceiling mounting.
Identification of controls on the device: Power/Level button and Segment display.
Details on using the remote control for power, heating levels, and timer functions.
Steps for initial start-up, including connecting the power cable and inserting batteries in the remote control.
Instructions for switching the device on via the mains switch and setting heating levels.
Programming automatic switch-off time in increments of 1 hour up to 24 hours.
Troubleshooting steps for when the device does not start or emit heat, and for RCD trips.
Troubleshooting steps when the device does not respond to the infrared remote control.
Activities required before starting maintenance, including switching off and cooling down the device.
Instructions for cleaning the device safely, avoiding water immersion and using appropriate cleaning agents.
Provides model, heating capacity, mains connection, plug type, protection type, dimensions, and weight.
Guidelines for proper disposal of the equipment according to regulations to prevent environmental harm.
Instructions for disposing of batteries and accumulators separately as hazardous waste.
To Next Page
