EN 9
radiant heater IR 2005
ð When mounting the device on the ceiling, only align the
device at an angle of30°to45° on both sides.
8. Once the device is at the desired inclination angle, tighten
the wing nut(8) again.
Start-up
Info
Odours might arise upon initial start-up or after a
longer period of non-use.
• Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
• Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
• Make sure that extension cables are completely unrolled.
• Make sure that there are no curtains or similar objects in
the immediate vicinity.
Prior to initial start-up, insert batteries in the remote control.
Connecting the power cable
• Insert the mains plug into a properly fused mains socket.
• Make sure that the power cable is guided along the back
of the device. Never guide the power cable along the front
of the device!
Operation
Operating elements
No. Designation Meaning
9 Power/Level
button
Switching the device on and off
For selecting the heating level
10 Segment display Heating level indication:
L1= heating capacity 800W
L2 = heating capacity 1200W
L3 = heating capacity 1600W
L4= heating capacity 2000W
Indication of the number of hours
during timer programming
Remote control
All settings of the device can also be made using the remote
control included in the scope of delivery.
No. Designation Meaning
11 Power button Switch the device on and off
12 UP button Heating level/timer function
Increases the value.
13 Heating level
button
Setting the heating level
14 Timer button For enabling the timer function
Automatic switch-off in increments
of1h up to24h
15 DOWN button Heating level/timer function
Reduces the value.
To Next Page
Loading...
Need help?
General
