Trotec pac 2000 e - Condensate Management; Manual Condensate Draining

EN 17
local air conditioner PAC 2000 E
Condensate discharge (manual draining)
In cooling and dehumidification mode condensate is formed,
which is mostly discharged via the exhaust air.
The remaining condensate is collected in a container within the
housing. The condensate ought to be drained regularly.
If too much condensate accumulates, the device switches off
and indicates this by displaying the error code H8 on the
segment display(14). In addition, a brief acoustic signal is
emitted 8times.
1. Carefully transport or wheel the device to a suitable
location for discharging the condensate (e.g. a drain) or
position a suitable collection container under the
condensate outlet.
2. Pull the condensation drain hose out of the retaining clip.
3. Remove the rubber stopper from the condensation drain
hose.
4. Drain the condensate.
ð The error code will disappear as soon as the condensate
has been drained.
5. Reattach the rubber stopper to the condensate outlet.
Ensure the tight fit of the rubber stopper, for otherwise
there might be uncontrolled water leakage.
6. Reattach the condensation drain hose to the retaining clip.