Trotec TDS 10 P User Manual

8 EN
electric heater TDS 10 P / TDS 20 P
2. Use the screws and washers to mount the transport
handle.
Start-up
Info
Odours might arise upon initial start-up or after a
longer period of non-use.
When positioning the device, observe the minimum distance
from walls or other objects as described in the chapter
Technical annex.
A
B
C
C
D
• Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
• Set the device up in an upright and stable position.
• Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
• Make sure that extension cables are completely unrolled.
• Make sure that no curtains or other objects interfere with
the air flow.
• Make sure that the device cannot come into contact with
moisture or water.
Connecting the power cable
• Insert the mains plug into a properly fused mains socket.
• Make sure that the power cable is guided along the back
of the device. Never guide the power cable along the front
of the device!
Operation
• Avoid open doors and windows.
Control panel
2
5
No. Designation Meaning
2 Rotary switch
temperature
For setting the temperature via the
room thermostat
5 Selection switch
ventilation and
heating levels
For selecting the heating levels and
ventilation
0 : OFF
: cold air/ ventilation
: heating level 1
: heating level 2

Trotec TDS 10 P Specifications

General

Brand	Trotec
Model	TDS 10 P
Category	Electric Heater
Language	English