EN 5
fan heater TFC 16 E
Behaviour in the event of an emergency
1. Switch the device off.
2. In an emergency, disconnect the device from the mains
feed-in: Hold onto the mains plug while pulling the power
cable out of the mains socket.
3. Do not reconnect a defective device to the mains.
Overheating protection
The device is provided with a safety thermostat which is
activated by overheating of the device (when exceeding the
operating temperature).
Once the safety thermostat has switched itself on, the device
will be turned off.
When the device has cooled down sufficiently, the heating will
be switched back on.
Investigate the cause of overheating.
If the safety thermostat does not switch in the event of
overheating, the overheating protection will be tripped. In that
case the device switches off completely. If so, please contact
the customer service to have the overheating protection
replaced.
Tilt protection
The device TFC 16 E is equipped with a tilt protection switch.
The tilt protection is a safety device intended to minimize the
risk of fire in case the device is tipped over inadvertently. The
device will be switched off when knocked over (or if its upright
position is changed in any other manner).
The tilt protection switch is located at the bottom of the device.
It is impossible to use the device unless the tilt protection
switch(5) was pushed entirely into the device. This occurs
automatically when placing the device on suitable ground.
The tilt protection switches the device off when it is inclined by
a few degrees out of its vertical position. The tilt protection is
also tripped when lifting the device a little, e.g. for transport
during operation. The device can again be used as usual only a
few seconds after placing it back in vertical position and on
solid ground.
To Next Page
Loading...
Need help?
General
