Trotec TFC 19 E - Start-up; Initial Operation Notes; Operation; General Operating Advice

EN 7
fan heater TFC 19 E / TFC 20 E
Start-up
Info
Odours might arise upon initial start-up or after a
longer period of non-use.
When positioning the device, observe the minimum distance
from walls or other objects as described in the chapter
Technical annex.
A
B
C
C
D
• Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
• Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
• Make sure that extension cables are completely unrolled.
• Make sure that no curtains or other objects interfere with
the air flow.
• Do not position the device directly below a wall socket.
• Make sure that the device cannot come into contact with
moisture or water.
Connecting the power cable
• Insert the mains plug into a properly fused mains socket.
• Make sure that the power cable is guided along the back
of the device. Never guide the power cable along the front
of the device!
Operation
• Avoid open doors and windows.
Control panel
TFC 19 E
3
1
2
No. Designation
1 Function selector switch for heating levels and oscillation
0 : OFF
I : heating level 1 (1200W)
II : heating level 2 (2000W)
: heating level1 and oscillating
: heating level2 and oscillating
2 Rotary switch room thermostat
3 Operating light
TFC 20 E
1
3
2
No. Designation
1 Function selector switch for heating levels and oscillation
0 : OFF
I : heating level 1 (1000W)
II : heating level 2 (2000W)
: heating level1 and oscillating
: heating level2 and oscillating
2 Rotary switch room thermostat
3 Operating light