To Next Page
L
Larry Barnes DDSAug 9, 2025
How to fix Troy-Bilt Pressure Washer that won't produce pressure?
- TtburkeAug 9, 2025
If your Troy-Bilt pressure washer isn't producing pressure, several factors could be the cause. First, ensure you're using a high-pressure spray tip instead of a low-pressure one. If the water inlet is blocked, clear it. Make sure the water supply is adequate and that the inlet hose isn't kinked or leaking; straighten the hose or patch any leaks. Check and clean the inlet hose strainer, and ensure the water supply isn't over 100°F. Also, check for blockages or leaks in the high-pressure hose and clean the spray tip if it's obstructed. If the gun leaks, consider replacing it. If none of these steps work, the pump may be faulty, and you should contact an authorized service facility.
General
