Tru-Test EC-10 - Plate Meter Not Running Freely (Low Results); Metal Shaft is Bent; Grass or Soil Build-up; Flutes on Steel Shaft Filled

28
Check
Resolution
Metal shaft is bent.
Straighten or request a replacement
part from your service agent.
Grass or soil build-up inside case.
Clean the plate meter.
Flutes on steel shaft have become
filled with grass or soil.
Clean the plate meter.
Check
Resolution
Buttons not clicking or activating.
Service - membrane needs replacing.
Send the plate meter to your service
agent.
Check
Resolution
The plate meter is switched on.
If you wish to select the inbuilt default
formula.
Hold down the ‘Formula’ button until
the display changes to ‘F_ _d’. While
the ‘d’ is displayed, press the ‘Reset’
button. The following equation is
used:
Cover (kg DM/ha) = 140 x height
+500
For warranty and servicing information, see www.livestock.tru-test.com/en-nz/product-warranty
For repair and servicing within New Zealand, ship to the address below.
(Unscrew the plate before packaging the plate meter).
8 Weld Street
Feilding
4702, Tel: 06-323 6146
For all support, phone
0800 AGDATA (0800 243282)