TRUArt Pyrography Pen - Features

Copyright 2020 TRUArt LLC
5
operaonal temperature in less than thirty seconds – me well spent when considering
the possible alternaves that could occur by not turning the unit o.
8. If the handpiece begins to make noise and stops heang, turn it o and re-ghten the
p holder using pliers. If that does not help - turn o the tool and replace p. If the
handpiece sll does not work with the replacement p, it might be defecve - please
contact us to arrange repair and/or replacement.
9. If a unit begins to make noise or buzz, turn it o, allow the pen to cool, and change
pens. Usually, an occurrence such as this is indicave of a shorted pen. If the noise
connues with a new pen, you should contact us to ascertain the cause of the problem
and/or make arrangements to return the unit.
10. Keep wood scraps available to check heat sengs and to pracce strokes. To maintain
uniformity, the test piece should be the same type of wood as the work piece you will
be working on.
Features