True Induction TI-1B - Installation Procedures and RV Use

III. Geng Started
-Plug the power plug into a standard outlet.
-The Power switch will light up and the unit will
sound to indicate on.
-The device will remain in standby mode, awaiting
user direction.
-Place ferromagnetic cookware (with water, oil, or
food already inside) on the center of the glass ceram-
ic top center.
-Now press Power button on the control panel, this
will turn the cooktop on. The power display will blink
and sound another indicator. Then press the Heat
button.
-The pre-set power level “5” is the default selection
as the device turns on.
-Using the +/- keys, you can change the settings
2
II. Specicaons
Power: 1600 Was
Voltage: 120V ~ 60Hz
Temperature Range: 150°F - 450°F (approximate temper-
ature sengs)
Level Selecon: Select sengs 1 through 10
Max Time: Set mer up to 150 minutes
Material: Glass Ceramic Top
Single Burner Dimensions: 11 13/16” width x 14 15/16”
length x 2 13/16” height
Using the Temperature Seng:
-Aer the unit is turned on, you can opt to use the TEMP seng. To do this, press the funcon key labeled TEMP one
me. The pre-set temperature is 270 degrees Fahrenheit.
-Using the +/- keys, you can change the temperature seng at any me. Sengs range from 150-450 degrees Fahren-
heit. (Approximate temperatures: 150, 180, 210, 240, 270, 300, 330, 360, 390, 420. and 450°F)
Using the Timer Funcon:
-After selecting the HEAT or TEMP mode, press the TIMER button once. The display will show the number “0”. Using the
+/- keys, you can increase operating time by 5 minute intervals (up to 150 minutes max) and reduce operating time by 1
minute intervals
-The display will count down the duration in minutes. Once the time is up, the cooktop emits an audible sound and
automatically goes into standby mode. To continue cooking, press the Power button to restart.
-During the timer operation, you can change the timer duration at any time with the +/- keys. The cooktop’s built-in
memory maintains the HEAT or TEMP setting previously entered.
-You can also change the HEAT or TEMP settings without affecting the current timer setting.