............ www.truemfg.com ............
True Food Service Equipment, Inc.
8 8
Final Location
A. Place styrofoam corners behind cooler for cushion and
carefully tilt unit on it’s back.
B. Remove the louvered grill by removing four phillips-head
screws.
C. Remove the four bolts from the skid with an adjustable
wrench, and locate the four castors. Castors are placed
inside cooler, within the bubble wrap.
D. Install one castor in each of the four female threaded areas
as indicated.
NOTE
Two out of the four castors are designated with an “F” for front.
These are provided with hand-brakes. Position these castors in
FRONT of the unit.
E. When all castors have been threaded fully, replace grill
and lift unit; positioning it into its final location.
F. Ensure that the two front castors are positioned
FORWARD as illustrated and locked down with the
hand-brakes.
WARNING
Unit may tip forward if procedure “F” is not
strictly followed.
G. Units final location should be adequately ventilated.
Conditions where heat exceeds 100ºF require an exhaust
fan.
H. Ensure that the drain hose for hoses are positioned in the
pan.
I. Free plug and cord from inside the lower rear of the
cooler (Do Not Plug In.)
WARNING
Warranty is VOID if ventilation is insufficient.
J. The unit should be placed close enough to the electrical
supply so that extension cords are NEVER used.
WARNING
Cabinet warranties are void if OEM power cord is tampered with.
TRUE will not warranty any units that are connected to an exten-
sion cord.
K. Proper leveling of your TRUE cooler is critical to
operating success. Effective condensate removal and door
operation will be effected by leveling. Adjust castors or
add shims.
INSTALLING OPTIONAL CASTORS ON A T-12FG
INSTALLATION / OPERATION INSTRUCTIONS
POSITIONING OF THE
CASTOR IS CRITICAL.
ORIENT THE CASTOR IN
THE FORWARD POSITION
AS SHOWN
To Next Page
Loading...
Need help?
General
