True T Series User Manual

............ www.truemfg.com ............
True Food Service Equipment, Inc.
27
27
INSTALLATION / OPERATION INSTRUCTIONS
REQUIRED TOOLS
•none

STEP 1
Locate rubber gasket behind lamp holder
mounted to evaporator housing. (See
Image 1).
STEP 2
Fit the bottom edge of the lamp cover
into the bottom groove of the rubber
gasket and rotate upwards while working
the edges into the rest of the rectangular
groove. (See Images 2-3).
(slide fingers underneath top edges of
rubber gasket and push rubber over the
top lip of the lamp shield)
STEP 3
Be sure lamp cover is seated properly in
rubber gasket.
- IMPORTANT -
Before replacing light cover
turn cabinet on and wait until it
reaches temperature.
NOTE
If cabinet is turned off and
interior allowed to warm up lamp
cover may become loose and
require reinstallation.
Follow directions above.
- IMPORTANT -
Before replacing light cover
turn cabinet on and wait until it
reaches temperature.
IMPORTANT
Before installing lamp cover turn
cabinet on and allow it to reach
temperature.
Rubber Gasket
Lamp Holder
Lamp Cover
Light Cover Installation for T-12FG
1
2
3

True T Series Specifications

General

Lighting	LED
Manufacturer	True Manufacturing
Series	T Series
Voltage	115V
Defrost Type	Automatic
Annual Energy Use	Varies by model
Exterior Finish	Stainless steel
Insulation	Polyurethane foam
Shelves	Adjustable, PVC coated wire
Compressor Location	Bottom
Category	Refrigerator
Number of Doors	2
Material	Stainless Steel
Type	Commercial refrigerator
Capacity	Varies by model
Color	Stainless Steel
Energy Star Certified	Yes
Door Bins	Varies by model
Height	Varies by model
Width	Varies by model
Depth	Varies by model
Weight	Varies by model