19
c) Introducing the decalcification agent
Tasks outside the RV
• Irritation of skin and eyes
in case of contact with decalcification
agent. Wear protective gloves, eye protec-
tion and face protection to avoid contact.
• Fill the water inlet filter with 6 Truma
AquaGo® decalcification tablets (content of
one blister pack).
Fig.12
• Re-insert the water inlet filter. See Step 9 in
“Draining the water and cleaning the water
inlet filter” on page15.
• Switch ON the appliance at the POWER
switch.
d) Filling the water system
Tasks within the RV
• Turn on fresh water supply or switch on
water pump
The decalcification tablets dissolve in
water quickly (approx. 10 minutes). So
that the decalcification agent is not rinsed
out, when filling, run the water only as long
as necessary. The Truma decalcification tab-
lets color the water slightly red.
• Fill the water system.
– Open all water-release points, e.g., hot
water faucets, showers, toilets.
– Once water flows uniformly, the water
system is vented.
– Close the water-release points.
You must bleed the water system thor-
oughly otherwise the circulation pump can-
not circulate the decalcification solution.
e) Starting decalcification
Tasks within the RV
• Set the control panel to “Clean”.
– If decalcification does not start, switch the
appliance on at the POWER switch.
f) Rinsing the water system
• You will need about 8 gallons of water
to rinse the water system.
• Dispose of (used) decalcification solu-
tion in accordance with local laws and
regulations.
Tasks within the RV
• Open all water-release points, e.g., hot wa-
ter faucets, showers, toilets.
• Run the water until the status LED 3 (Fig.9)
on the control panel goes out.
• Set the control panel to “Off”.
• Close all water-release points.
• Turn OFF the water supply or switch OFF
the water pump.
• Open a hot water faucet to relieve pressure
in the system.
To make sure that the appliance and the
water pipes contain no decalcification
agent, empty the water system again and
refill it.