To Next PageTo Next PageWhy is the circulation pump not working in my Truma Water Heater?
If the circulation pump in your Truma Water Heater isn't working, the issue might stem from a lack of power. Ensure the power supply is sufficient and properly connected. Alternatively, the circulation pump itself could be faulty, requiring inspection or replacement.
What to do if water is leaking at the circulation adapter in my Truma AquaGo?
If you notice water leaking at the circulation adapter of your Truma Water Heater, it could be due to a dirty O-ring. Try cleaning the O-ring and the surrounding surface with clean water. If the O-ring is damaged or missing, you should inspect it and replace it if necessary.
General| Fuel Type | Propane |
|---|---|
| Ignition | Electronic |
| Power Source | 12V DC |
| Water Connection | 1/2" NPT |
| Safety Features | Overheat protection, automatic shut-off |
| Type | Tankless Water Heater |
| BTU | 40000 BTU/h |
| Gas Connection | 3/8" Flare |
| Freeze Protection | Yes |
Defines warning symbols and signal words for safe operation.
Covers expert installation, chemical warnings, and specific lever safety advice.
Determines how often decalcification is needed based on water hardness and usage.
Steps to prepare the system and mix the decalcification solution.
Instructions and diagram for connecting the circulation pump.
Step-by-step guide for performing the decalcification procedure.
Procedure for cleaning the circulation pump after use.
Instructions for flushing the water system after decalcification.
Guidance on how to stop the decalcification process.
