Truma BGF 10 - Disposal; Fuses; Technical Data

Fuses
The 12 V fuse for the boiler is on the electronic control unit on
the device.
1,6 A
Figure 3
The fine fuse on the electronic control unit must always be
replaced with a fuse of the same type: 1.6 A (slow-acting),
EN 60127-2-3.
Disposal
The appliance must be disposed of in accordance with the ad-
ministrative regulations of the respective country in which it is
used. National regulations and laws (in Germany, for example,
the End-of-Life Vehicle Regulation) must be observed.
Technical data
Determined in accordance with EN 15033 or Truma test
conditions
Manufacturer
Truma Gerätetechnik GmbH & Co. KG
Postfach 1252
85637 Putzbrunn (Munich)
Germany
Protection type
IP20
Water capacity
10 litres
Pump pressure
max. 2.8 bar
System pressure
max. 4.5 bar
Type of gas
Liquid gas (propane/butane)
Operating pressure
30 mbar
Nominal heat load
Q
n
= 1.5 kW (H
i
); 120 g/h; C
13
; I
3B/P
Heating time from approx. 15°C to approx. 70°C
Gas mode: approx. 31 min.
Voltage supply
12V
Power consumption at 12V
Ignition: 0.25 A
Heating: 0.21 A
Standby: 0.06 A
Standby – gas consumption
approx. 70W
Weight without water
7.5kg
Destination countries
BE, BG, RO, DK, DE, EE, FI, FR, GB, GR, HR, IS, IE, IT, LV, LT,
LU, MT, NL, NO, AT, PL, PT, SE, CH, SK, SI, ES, CZ, HU, CY
E1 10R-05 2604
Subject to technical changes.
Dimensions
All dimensions in mm.
Water
connections
Gas connector
Electronics
Cowl
261
360
347
454
74
24
Figure 4
11